Since the last updates (I think since build 39) the condition block is locked to change the values in the optimization range:
For example, when you have 2 conditions or more and you want optimize if one condition or two conditions are the best solution for your strategy, actual it is not possible to change the start and stop value, these function is closed.
Would es be possible open this function again as in the earlier building versions?
Regards Christian
For example, when you have 2 conditions or more and you want optimize if one condition or two conditions are the best solution for your strategy, actual it is not possible to change the start and stop value, these function is closed.
Would es be possible open this function again as in the earlier building versions?
Regards Christian
Rename
These were always locked. It doesn’t make sense to change the values. There are only 2 conditions so an optimization of 1 to 2 by 1 is enforced.
Sorry Glitch, but this is not true. I often used in the past 7 conditions in the multi condition block and I want to know what are the best combination, should I confirm 4, 5, 6, or 7 conditions at the same time, but 4 is minimum. In the past I use the range 4-7 in the optimization run.
How can I handle this challenge?
Regards Christian
How can I handle this challenge?
Regards Christian
I'm looking at the change history of this component and there were no changes made around the parameters being read only or changeable. They were ALWAYS read only. You can't change it.
Your Response
Post
Edit Post
Login is required